Short Circuit Rules Setting In Altium

[sgaltium]

Hi,

Any expert can tell what is the setting in rules that to fix “auto routing” do not route with short circuit? I got play around “short-circuit” rule but result still routed with few short circuit wires, maybe I set it wrong, any one can guide how to set correct rule to prevent this ?

Thanks.

 

[wizpic]

It should never happen unless you have got the boxed ticked saying allow short circuits in the rules editor or your board has not been fully auto-routed if this is the case the when you click auto route look towards the bottom where you click auto route tick the box rip up violations after routing

 

[sgaltium]

In rules setting:

ShortCircuit – box un-tick
UnroutedNet – box un-tick
Rip up violations after routing – box tick

Result after routed:
Contentions =2, Failed to routed = 0 , 100% finished.

Under “Design Rule Check” report:
Short Circuit = 0
Un-routed Net – 0

Physically found one net un-route, why this will happen?
What it mean “Contentions =2” under completion report?


Thanks.