Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

seven segment display using rs 485 protocol & P89V51RD2

Status
Not open for further replies.

sidatsaace

Newbie level 5
Newbie level 5
Joined
May 11, 2009
Messages
8
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,283
Activity points
1,338
rs485 protocol

hi to all
im interfacing the controller with a device which ll collects data from GPS receiver and converts it into RS485 format. my interfacing is made through a converter IC 26ls32(converts rs485-rs232) the prob is if i place the cable(b/w the device and my module) among heavy distribution lines due to some matching with those heavy feeder lines the IC gets damaged. what can i proceed with an alternate step.(imp note:-it must be very economic)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top