hi
the IDE doesnt deside which type of hardware u wnat to use u have to physically connect the PIc to a 7segment display & program the controller such that i will out put the number that u pressed on the input side here is sample circuit.
the 7 sement should be either common anode/cathode type
Really a lot information regarding this topic on the Internet.
Attached find documents show the full source code and schematic that I used for one of my commercial projects in the past.
Driving 4" 7-segment LED. Multiplexing method used. Development in CCS C programming language. Pictures found under my web page under PIC Boards section.