serial ADC Data Transmission using uART 8051.

Status
Not open for further replies.

sidy50

Member level 4
Joined
Dec 31, 2009
Messages
79
Helped
14
Reputation
28
Reaction score
3
Trophy points
1,288
Location
India
Activity points
1,839
Hi all,
Theres an extremely important help, i need in my project...

Here is what happens to be done...
An ADC0808 converts analog data into 8 bit Digital Data...
Now i want to transmit this Data serially through UART of 8051 & Display this data on anyone of the Ports of the other 8051uC...i have C routines for UART & ADC conversion...
But m not able to make it work properly...The Displayed Data on the Ports is Incorrect.

Pls help me, how can i make this work
Any suggestions or Similar Codes would help...

Thanx & Regards.
Sidy.
 

Did you change any configuration registers for ADC?
Regards,
Jerin.
 

No, i didnt do anything like...
I used some routines for ADC conversion...It Works
Then UART routines to transmit serially...
& Recieving UART routines at the receiver Side...

Both things when Tested Separetely Works fine...
Dunno whats wrong...
Should i post the whole code..?

Thanx.
Sidy
 

how are you taking 8 bit digital data on the UART of 8051.. i guess u'll need to take all d 8 bits first at the controller and then send it to wherever desired.

see of these help : **broken link removed**
**broken link removed**
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…