Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Sendust Torroid used in HV Buck LED driver

Status
Not open for further replies.
C

cupoftea

Advanced Member level 5
Joined
Jun 13, 2021
Messages
2,363
Helped
51
Reputation
102
Reaction score
102
Trophy points
63
Activity points
12,240
Hi,
We are doing a DCM Buck LED driver. (LTspice attached)

F(sw) = 90kHz.
Vin = 390VDC
V(LEDs) = 228V
P(LEDs) = 155W
Peak L current = 2.15A
L = 62 turns round a MS-157060-2 sendust torroid. (2 strands of 0.315mm Enamelled copper wire)

The core loss adds up to 2W. Internal enclosure ambient is 60 degrees. Do you think the torroid will be OK?


MS157060-2 TORROID


Sendust material

MS - Sendust - Micrometals

www.micrometals.com www.micrometals.com
 

Attachments

  • Buck HV.zip
    1.7 KB · Views: 71

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top