Sending data between AM receiver and transmitter using UART

Status
Not open for further replies.
Z

Zhane

Member level 5
Joined
Feb 2, 2008
Messages
89
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,876
say i have a pair of AM receiver and transmitter... how should I use it to send data from 1 receiver to 1 transmitter end?

should I use uart?
how should I encode the data? I've read about manchester encoding..but it's rather complex. does anyone has the C source for it?
 

Re: RF & PIC

HI,

U have to use the UART here.

First you have to send preambles for proper reception and sync word for every packet to ensure byte Synchronisation
 

Re: RF & PIC

dont really get you...

1 packet is 8N1?
so i have to send 2 packets of 8bit data?

erm...how can i receive 2 packets of them?
 

Re: RF & PIC

HI,

A packet means it is a collection of bytes. Preamble is sent first and then the sync word then the actual data finally the CRC for error detection.I hope u got it.
 

Re: RF & PIC

i tried.. sending 0xFF all the time, and only data when required.

my receiver... ignores all 0xFF, and only decode non- 0xFF

but.. doesnt quite respond to the way i want it to be
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…