Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

selective R extraction with Calibre

Status
Not open for further replies.

duling653

Newbie level 1
Joined
Jun 8, 2015
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
6
Full RC extraction using calibre making the netlist too large to run simulation. Is there any way to extract all C but selectively extract R for only a few critical nodes?
 

slizak

Member level 5
Joined
Nov 15, 2013
Messages
81
Helped
15
Reputation
30
Reaction score
15
Trophy points
1,288
Activity points
2,025
Yes, there is. In the xRC or xACT manual, look for a section called "Extracting a Netlist with Mixed Parasitic Networks." (Section titles change some times, so if your manual doesn't have that section, search for "PEX Extract Include" - the SVRF command you want.) The current manual on SupportNet gives instructions for doing it with Calibre Interactive or modifying your files.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top