Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Scope mesurment two chanels

Status
Not open for further replies.
I

iliya24

Member level 2
Joined
Dec 15, 2011
Messages
50
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,609
Hello.
Can u help me to understand if i want to measure to signals say one of them 100khz and the second is 1khz wich one of the should be the triger on scope.
Thx.
 

It depends on which waveform you wish to view without jitter.

Also on whether you want to examine where the two signals coincide, etc.

Going by first thought, you would trigger on the slower signal, and set the sweep time to view the entire waveform.
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top