Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

SAW filter model in MATLAB or ADS [hlp]

Status
Not open for further replies.

elec350

Full Member level 4
Joined
Dec 17, 2006
Messages
199
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,296
Location
Iran
Activity points
2,548
filtr ads model

hello
Can we model the SAW filter in MATLAB or ADS? Is there any model now?
 

there is a model in ADS , but u need to specify the paramters like the BW , insertion loss and so on

Khouly
 

    elec350

    Points: 2
    Helpful Answer Positive Rating
Hello
khouly wrote:

there is a model in ADS , but u need to specify the paramters like the BW , insertion loss and so on
pls specify the model for me explicitly.
 

The "SAW_Filter" (in the Filters-Bandpass libary), as khouly suggests, provides an electrical model for SAW devices. There is also a library of standard Sawtek filters under System Library > Filters.
 

It's also possible to define the frequency response of a SAW filter by writing s-parameter by hand at some critical frequencies.( as much as possible) then by using model composer of ADS, you may obtain a discrete lumped element equivalent of the filter.
Of course SAW filter will show a bandpass filter behaviour and to obtain a very accurate model is very tough.But it's worthy..

Normally, an industrial SAW filter has s-parameters,you can use them in model development..
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top