Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

SAR Analysis using phantom models available in Ansys Electonics (HFSS 19)

Status
Not open for further replies.

peace1

Newbie level 2
Joined
Jun 1, 2019
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
22
I need to simulate a patch antenna for SAR Analysis using phantom models available in Ansys Electonics (HFSS 19).

From a tutorial video, i noticed that the whole phantom and antenna are required to be placed inside the radiation box. I used lump port to excite patch, placed it above phantom at 5mm distance and tried to simulate but its giving error. (too many conductors crossing lump port)
the patch antenna shows successful simulation results without phantom.
 

sri1710

Newbie
Joined
Nov 1, 2018
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
5
It simply means that your port is touching or crossing more than two conductors. Lumped element ports need to touch two ports. so make sure your size of the port is appropriate.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top