Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Rotate by particualr angle in ads

Status
Not open for further replies.
2

2010ee179

Member level 2
Joined
Jun 22, 2011
Messages
43
Helped
4
Reputation
8
Reaction score
3
Trophy points
1,288
Location
Pakistan
Activity points
1,555
I am using ADS 2009...I couldn't find any way to rotate a component (either in schematic or in layout) by particular angle...all it does is to rotate any component by 90 degree just...:roll:
Is there any way of doing that?
Hope I posted this question at right place...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top