Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

RF antenna to measure polarization

Status
Not open for further replies.

michwill

Newbie level 2
Newbie level 2
Joined
May 23, 2013
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,289
Is it possible to build a narrow-band antenna (or antenna+circuit) to measure the RF (or microwave) polarization?

Or, say, which amplitude is proportional to cosine of some angle between E and the antenna (however, I need 3 such antennas then)
 

To measure antenna polarization you can use a half-wave dipole or a waveguide horn. Their typical polarization separation is >30 dB if made geometrically "clan". Depends on frequency what you may prefer.
At microwave bands I used dipoles made of a thin metal sheet, to achieve >30 dB polarization ratio.
Locate this test antenna far enough from the tested antenna, on a common line, then turn one of the antennas on this axis. Record the maximum and minimum; their ratio is the polarization ratio of the antenna pair.

To achieve >>30 dB, it is recommended to use an additional grid made of parallel wires and located before the test antenna. The grid "purifies" the wave front by ~20 dB in polarization ratio.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top