Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

revival and recovery time?

Status
Not open for further replies.

neetinsingh

Member level 2
Joined
Jun 18, 2007
Messages
50
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,286
Activity points
1,607
what is revival and recovery time in digital ckt?


if u have some doc explaing it please upload it............
 

some one please reply this post.......
 

I heard about Recovery time & Removal Time.. Its similar to setup time & hold time, but we use these terminology only for asynchronous(Reset & set) pins.

What is revival time?.
 

yaa its removal time instead of revival time.......
 

Just Setup/holding timing between clock and async signal,for example, reset/set/clear and so on. There are many document about it.
 

stocking said:
Just Setup/holding timing between clock and async signal,for example, reset/set/clear and so on. There are many document about it.

can u upload some doc or can u provide some link...........

tht would b a great help.........

regards
neetinsingh
 

this is a discussion about recovery and removal time for asynchronous signals
 

if someone have a doc explaining with the help of waveform please upload it.........
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top