Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Resources about Schmmit Trigger

Status
Not open for further replies.

jimjim2k

Advanced Member level 3
Joined
May 17, 2001
Messages
996
Helped
23
Reputation
46
Reaction score
13
Trophy points
1,298
Activity points
7,192
Hi

Does someone could solve the following questions for the given figure?


1. Equations for VH, VL
2. Sizing of transistors handy formulas?
3. Spice netlist
4. Any other comment
5. A good description on the working schema of the circuit.


tnx
 

okguy

Full Member level 6
Joined
Mar 1, 2002
Messages
360
Helped
15
Reputation
30
Reaction score
9
Trophy points
1,298
Location
China
Activity points
2,650
Re: Schmmit Triger

I think you can find it in Baker's book and CMOS design and ...
 

jimjim2k

Advanced Member level 3
Joined
May 17, 2001
Messages
996
Helped
23
Reputation
46
Reaction score
13
Trophy points
1,298
Activity points
7,192
Re: Schmmit Triger

okguy said:
I think you can find it in Baker's book and CMOS design and ...

Hi

I have not access to them.
Would you please upload only that specified section.



tnx
 

amarnath

Advanced Member level 1
Joined
Apr 24, 2003
Messages
402
Helped
26
Reputation
52
Reaction score
7
Trophy points
1,298
Activity points
3,141
Re: Schmmit Triger

this is simply as follows.when the output (read voltage level at node "OUT")state is 1 and input is at zero.now,when output is logic one the source of tran M3 will be at Vdd-Vth3.now when the input is increased to Vth1,tran M1 turns on,this will start bringing the potential of source of M3 towards ground.so when the input becomes Vth2+Vsource(M3),then this is the switching point of the schmitt trigger,this is one switching point ,the other can be solved in the same manner ,for the pmos transistor when the ouptut is at logic 0 and input is at logic 1.now to find out the transistor sizes
,equaye the currents through transistors M3 and M1.M3 is in saturation and M1 is also in saturation just equate the currents to get the sizes.u get a ration x/y ,then size x and then get y.using the same principle size the pmos transistors.

regards
Amarnath
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top