resistor caculation problem

Status
Not open for further replies.
H

hycmos

Newbie level 3
Joined
Aug 23, 2005
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,311
hi guys,

i have a problem of how to design a resistor network to generate the needed voltage by using as few squares as possible. is there any normal procedure to do this? or depending on the experiences of the designer?

i wish there are some reference books to me. if you have any advice i will very happy. thans very much!
 

How many current does pass the resistor? What is the voltage range u mentioned?
 

huojinsi said:
How many current does pass the resistor? What is the voltage range u mentioned?
Click to expand...

hi, the current is below 1ma, and the voltage is below 5v, and i need more outputs than one. for eample, 2V, 3V, 3.3V, and so on.

but i think the value is not important. the key is how to do this.
 

My single understanding is designing a trimming resistor network. Trimming resistor can choose out. Pls see the figure.
 

    H

    hycmos

    Points: 2
    Helpful Answer Positive Rating
Use a unit resistor so that every output voltage can be selected on the terminal of one single unit resistor. For example, choose your unit resistor si that you have 100mV acros its terminals. So, you can have 2V across 20 unit resistors, 3V with 30 resistors, etc.
 

huojinsi said:
My single understanding is designing a trimming resistor network. Trimming resistor can choose out. Pls see the figure.
Click to expand...

thanks you.

your method depends on the wegiht. and, can not get the quite arbitrary&multiply output voltages. for example, i want to get a output of 1.61V and 2.05V. in this case, your strategy is disable.

Added after 1 minutes:


many resistors!
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…