Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Remove netlist from Allegro Board ..Help me, urgent!!

Status
Not open for further replies.

sugvivek

Member level 2
Joined
Jan 2, 2006
Messages
50
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,643
Dear All,

How to remove the entire netlist from allegro board.

Help me.!!
 

hi

You con't delete the netlist from the Allegro Board
You can change or delete from the schematics only
 

hi,
It depend on your licence, if you have SI610 or higher then you can edit the net in the layout.

so neena correct urself.

Binu G
 

Well deteting component or nets are not possible.If you delete component, it resided in place option & doesn't og off the design.

The only way is to edit schematic & reload netlist after packaging.

Good luck.
 

centiago said:
Well deteting component or nets are not possible.If you delete component, it resided in place option & doesn't og off the design.

The only way is to edit schematic & reload netlist after packaging.

Good luck.

hello Centiago,
i wonder that will the netlist too reside in place option !.

change the licence suite to si630
you can see Logic --> partlist
logic -- > edit nets

u can do wht ever u want it wont be in ur place option. try this!

binu G
 

Binu,

Best practice calls for change from schematic, when you edit schmatic & repackage, old netlist are replaced with latest design.

Read carefully, the question in thread was to remove the nets from design. There's absolutely no way you can delete nets on .brd file
 

Crentiago
u seem crazy !
not willing to agree.
i do understand that you have to delete from the schematic. but you can also do it in board file.

read the question carefully.

"How to remove the entire netlist from allegro board. "
not from schematic.

send me a file i will show you how to remove it :p

binu g
 

You DO NOT need to change editor.

Go to setup>User Preferences select Misc category then check logic_edit_enabled

This will allow you to remove nets and components from logic>net logic or logic>part logic menu.

Now if this is a proper way or not is entirely different issue!

Majnoon
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top