Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Remove Illegal characters from Orcad Library

Status
Not open for further replies.

buenos

Advanced Member level 3
Joined
Oct 24, 2005
Messages
953
Helped
40
Reputation
82
Reaction score
21
Trophy points
1,298
Location
Sunnyvale, California, USA
Activity points
9,039
Hi

is there a way to automatically change pin names in an orcad library?
for example replacing all <,>,/... characters to underscore?
I have lots of components with 400+ pins, and changing them one by one seems to be a horrible job to do.
If I could get the pin-list of one compoinent out and back in in a spreadsheet form it would be fine.
A schematics was already designed with the components, so i can not recreate the symbols from scratch, the pin positions have to remain the same.

im used to Altium where the pin names can have special characters...
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top