Regarding diffrential pair routing in expedition pcb

[arunrajendhar]

Hi All,

I have assigned some nets as differntial pairs in the constraints so when i route them it comes as diffrential but some time I need to route them as single ended especially near the end of diifpairs pads/vias and for length matching them.

Is there any option to route as single ended with the diffrential pair properties?

Now am removing those nets from the diff pair rule for length matching and retain back them to diffpairs rule once it get matched.

looking for your promt responses

 

[senilicus]

You can route a single line of a diff-pair in the following way.

- Go to route mode
- Press the alt-key, and keep it pressed.
- Click on the net you want to route.
- finish the net.