Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Well you can choose a microstrip inset feed patch. The length of the patch is given by L = c/(2*freq*sqrt(dielectric-constant)) [ This is first order equation will take you very close to your final design] and take width 1.2 times the Length (This is not a rule, I am saying so that you can begin your analysis)
Then feed the patch in the center by a 50 ohm feed line and keep moving towards (inset) the center until you reach a good match at your freq. of operation.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
