Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

recommendation PCB layout for SMT resistor

Status
Not open for further replies.
A

antenna_abc

Member level 3
Joined
Dec 22, 2005
Messages
58
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,835
0402 resistor dimensions

Hi, everyone.

I am going to make a PCB with a wikinson power divider, which includes a SMT 100 Ohm resistor. For the 0402 resistor, I got the dimension of it from the data sheet, for example 1mm length and 0.5mm width. But there is no recommends of the PCB pads.

My question is that what is the dimension of the pcb pads and spacing should I use for this SMT components? Thanks.

Sincerely
 

pcb resistor

This is related to manufacturing. Contact the local manufacturer and get the clearance details. You can use the standard pads but if the manufacturer can place much tighter then use the custom layout.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top