these two PIC'S are in single board or two boards? if these two pics having seperated boards means we can use RJ-9 connector for tranmistting data from one board to other board
ok can you tell me any link which could serve my purpose a bitRC-5 is just a protocol for IR commands. It corresponds to remote control, because remote control works on IR Codes only.
You can use it for any IR Codes, not only Remote control.
yup wireless communication but using ir(rc5 protocol) onlyLet me ask a question here -
Do you want to have wireless communications between two PIC( I assume that PIC micro-controller ) ?
with regards,
Milind
I think My question hurt you it seems... from the answer that you given in post....My intention was to understand your requirement .... Now to answer your question .... As a part of learning it is good exercise and I will definably work .... It is based on the capacity of your coding skills .... Also the hardware that your have....
Here are some of the points that you need to consider ....
1) Do you want the Communication to be one ways or two way i.e. Both can acts as master or master -slave or even slave master etc.
2) Is you will like to have acknowledgement concept
3) What is strength of your IR signals
4) RC-5 spec is based on 38 Khz signal based sampling
5) Also RC-5 works mostly in broad-cast case of communication ....i.e No concept of acknowledgement ....
6) Do you like to have encryption in the communications
7) What about the decryption in the signal ( I mean CRC or some thing like that staff is a part of this )
First one need to think all of these aspect ....
I hope you understand my intention to ask this question...
Good Luck
No i was not hurt i am just clueless ,only one way communication is required,no encryption sort of thing is required just transmitting a single message from transmitter and displaying on receiver.They will be very close to each other so give me the advice regarding ir strength needed alsoI think My question hurt you it seems... from the answer that you given in post....My intention was to understand your requirement .... Now to answer your question .... As a part of learning it is good exercise and I will definably work .... It is based on the capacity of your coding skills .... Also the hardware that your have....
Here are some of the points that you need to consider ....
1) Do you want the Communication to be one ways or two way i.e. Both can acts as master or master -slave or even slave master etc.
2) Is you will like to have acknowledgement concept
3) What is strength of your IR signals
4) RC-5 spec is based on 38 Khz signal based sampling
5) Also RC-5 works mostly in broad-cast case of communication ....i.e No concept of acknowledgement ....
6) Do you like to have encryption in the communications
7) What about the decryption in the signal ( I mean CRC or some thing like that staff is a part of this )
First one need to think all of these aspect ....
I hope you understand my intention to ask this question...
Good Luck
You dont have to be sorry.I dont know who is right about encryption but i dont require it whatever maybe the case.I just have to send simple predefined message of 32 characters and have to display it on receivers's (pic) LCDGuys I am sorry ...if you fell this is Confusing....
Good Luck
no link seems to be guiding meHi,
Some links that might guide you -
http://www.picprojects.net/rc5_decoder/index.html
https://www.edaboard.com/threads/156916/
**broken link removed**
http://www.sixca.com/eng/articles/remote/index.html
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?