Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

questions on Mask slivers and solder bridge on layout design

Status
Not open for further replies.
N

n_raghavan07

Junior Member level 3
Joined
Jun 19, 2009
Messages
28
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Bangalore
Activity points
1,453
solder bridge

Few questions on Mask slivers and solder bridge on layout design.
1. What is the basic difference between above two?
2. What are the causes of above two in terms of PCB manufacturability?
3. Is there any specific guideline for above two?
4. How above two forms on PCB?
5. How to determine above two values on design?

Regards,
N.Raghavan
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top