vhn
Member level 4
Question on TMS320F2812
Hi,
In TMS320F2812 I'm using the external interface (XINTF) for accessing an external RAM. I need to use the DMA feature provided on the chip. I notice that the data sheet always refers to the "hold mode" being enabled for DMA to function.
But in the XINTCNF2 register, the "HOLD" bit is marked "Read-Only".
So how can we enable the hold mode while using XINTF?
If you have any idea, please reply.
Thanks,
vhn
Hi,
In TMS320F2812 I'm using the external interface (XINTF) for accessing an external RAM. I need to use the DMA feature provided on the chip. I notice that the data sheet always refers to the "hold mode" being enabled for DMA to function.
But in the XINTCNF2 register, the "HOLD" bit is marked "Read-Only".
So how can we enable the hold mode while using XINTF?
If you have any idea, please reply.
Thanks,
vhn