Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

question about RFID coild verification

Status
Not open for further replies.
Z

zhangm79

Member level 1
Joined
Apr 5, 2006
Messages
38
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,286
Activity points
1,491
Hi, guys.
i am doing RFID coil design currently,but doubt how to verify coil without tag chip.
1.Is it possible to tune coil to 50ohms and add one differential 50ohms load to estimate the chip's impedance, then measure voltage between two end of load? if it works, how to design differential 50ohms load?
2.is it possible to design one differential load to estimate any complex impedance of tag chip?

thanks.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top