wilfwolf
Newbie level 6
I imported Verilog RTL code into spw,and one symbol is generated.
then i set up a system,which this symbol is included. i specified
the "cds.lib" directory in simulation manager and choose "SPW-NC" as
the engine. it works as expected. But if i have two symbol which are
generated from verilog RTL code,so there are two "cds.lib" files in
diffrent directory,how can i specify the directory in simulation
manager? please help me!
then i set up a system,which this symbol is included. i specified
the "cds.lib" directory in simulation manager and choose "SPW-NC" as
the engine. it works as expected. But if i have two symbol which are
generated from verilog RTL code,so there are two "cds.lib" files in
diffrent directory,how can i specify the directory in simulation
manager? please help me!
