Sometimes it may be ground related, check that you have a gnd connected.
Alex
90% of my time wasted is because of simulation problems. all convergence problems. wish this never exists.but no pains no gains.
Well here is my new problem. In the attached word file. It shows the two symmetrical circuit. when i simulate single of it. (deleting other) the simulation goes fine. but when same other is added it gives error.I have put the error in the fig.2 and third shows, the net where the problem exists. it shows in red.
Please, upload the .DSN document.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?