RollingEEE
Full Member level 3
- Joined
- Mar 25, 2006
- Messages
- 165
- Helped
- 8
- Reputation
- 16
- Reaction score
- 7
- Trophy points
- 1,298
- Location
- Bangladesh
- Activity points
- 2,406
Hello,
I am using proteus 7.1 SP 4. I was simulating a circuit. It worked fine for couple of times, then it happened. I tried to 6 (0110) to a flipflop. Gave it clock pulse, and the flipflop loaded 7 (0111). I tried to run it several times, decreased the simulator minimum time step no use. I even tried to see if the clock had some ringing and use. (I used a counter, and it gave only one CP in the load.)
Can any one explain the phenomenon?
I am using proteus 7.1 SP 4. I was simulating a circuit. It worked fine for couple of times, then it happened. I tried to 6 (0110) to a flipflop. Gave it clock pulse, and the flipflop loaded 7 (0111). I tried to run it several times, decreased the simulator minimum time step no use. I even tried to see if the clock had some ringing and use. (I used a counter, and it gave only one CP in the load.)
Can any one explain the phenomenon?