Proteus Simulation not working right

Status
Not open for further replies.
R

Redhat66

Newbie level 4
Joined
Dec 24, 2016
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
41
Please I tried running a simulation on proteus. An ac source is connected to a step down transformer which is then connected to a bridge rectifier after which the dc output is filtered with a capacitor. I connected an led to indicate if the current was flowing , but it keeps bringing about these error.

[SPICE] transient GMIN stepping at time=0.590774
Simulation is not running in real time due to excessive CPU load

I have tried all sorts of things, but nothing is working. I need help.
 

Hi,

Why not simply posting your circuit?

Often with AC source and rectifier you just need to connect a very high resistor across one rectifier diode to prevent from floating (undefined) nodes.

Klaus
 
Please find attached the circuit. Thank you
 

Hi,

* Connect primary side with 1G to GND
* Connect secondary side with 1G to GND

Klaus
 
Thanks a lot. I'll try it out
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…