hi,
i am sorry. i can't get what you say. "Please put the proteus simulation page snap shot with error......."
please tell me in detail about that......
thanks....
connect a pot of 10k to pin 3 of lcd... one end to +5V middle pin to pin 3 and other end of pot to ground.
then vary the pot value to see some box in lcd and then to see the output... and as alex told,, ground the unused LCD data pins....
Hi i am Novice to the JHD162A lcd..
Issues: Symbols appearing even the correct data has been sent.
Controller: 89S52
Data line: port0 --connection with lcd is 8bit.
Plz somebody help me...
---------- Post added at 13:12 ---------- Previous post was at 12:56 ----------
Hi i am Novice to the JHD162A lcd..
Issues: Symbols appearing even the correct data has been sent.
Controller: 89S52
Data line: port0 --connection with lcd is 8bit.
Plz somebody help me...
Hi,
i am loaded a program that working in a PIC16F877A, it work in a real board, but the same is not working Proteus simulation. when i am connecting the variable pin of the POT to the VEE pin of LCD, no signal is getting to that pin. i also connected VEE Pin to ground then no black boxes is getting.
the screen shoots i given below..
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?