Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Protel problem when making multiple small PCBs on bigger one

Status
Not open for further replies.
R

Robby

Member level 2
Joined
Jan 24, 2002
Messages
50
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,286
Activity points
419
Pro*tel Problem

Hello,

following problem occours if pr*tel is used to create multiple small pcb's on
a greater one.
The single small one was created as usual. Then this one was placed using
paste special (there are some options in contrast to ordinary paste) on the target board.
Now the following happens: The original small one, originally overcast by a polygon plane
for copper contain the dead share copper originally removed, again.
No option I have discovered works. Why does this happen?
If somebody know a solution, it'd be fine. 8O

thanks

Robby
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top