Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Protel DXP trace width

Status
Not open for further replies.
Y

Yham

Newbie level 6
Newbie level 6
Joined
Mar 11, 2002
Messages
12
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
76
Hi,

Hope some of you guys still use Protel DXP 2004. Is there a way to change a trace width except to go to the Design/Rules... ? I am manually designing a board, and would like to be able to change it on the fly. Is it possible?

Milosh
 

johnyaya

johnyaya

Full Member level 2
Full Member level 2
Joined
May 30, 2001
Messages
125
Helped
17
Reputation
34
Reaction score
0
Trophy points
1,296
Location
YoyoDyne
Activity points
1,106
After you set the first point of the trace, press tab to open the properties dialog.
 

    Y

    Yham

    Points: 2
    Helpful Answer Positive Rating
Y

Yham

Newbie level 6
Newbie level 6
Joined
Mar 11, 2002
Messages
12
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
76
Re: P*otel DXP trace width

johnyaya said:
After you set the first point of the trace, press tab to open the properties dialog.[/1quote]

Hi Johnyaya,

this is the answer I am looking for. I spent three hours without success. Thanks a lot for response.

Milosh
Click to expand...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top