Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Programming PIC18FxxJxx - help needed

Status
Not open for further replies.
D

dzedze

Newbie level 1
Joined
Nov 2, 2009
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,286
Programming PIC18FxxJxx

Hello everyone, I'm trying to Brenner8-P and attachments thereto to program PIC18F97J60, but not doing well. Does not recognize the chip. If someone has already failed, please help.
 

Re: Programming PIC18FxxJxx

The pic should be supported by the programming software. I don't know this programmer, but are you using the latest firmware? Or should this PIC not be programmed with 3V3 instead of 5V (i.e. with a Brenner9 apparently, or signal-adaptation circuit)

Added after 12 seconds:

The pic should be supported by the programming software. I don't know this programmer, but are you using the latest firmware? Or should this PIC not be programmed with 3V3 instead of 5V (i.e. with a Brenner9 apparently, or signal-adaptation circuit)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top