Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Problems with hardware-co-simulation in simulink (spartan 3 xc3s-pq208) in XFLOW

Status
Not open for further replies.

sudiitr

Newbie level 1
Joined
Sep 5, 2012
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,289
Hello everybody.
I am experiencing problem in hardware co-simulation in spartan 3e board. I am designing a system that requires two consecutive multipliers.
for single multiplier the system works fine. however, when both multipliers are there, during generation of JTAG block, towards the end of XFLOW it shows an error, with error code 30.
Can anyone please explain this and suggest a remedy. here are the hardware details:

Board-spartan 3 xc3s-pq208

Hardware used: From register block(shared memory)(2), multipliers(2), gateway out.for 1st multiplier both inputs come from same register.
Register width:-32bit(signed,30 bit floating point)
gateway port-32 bit(IOconnector7 is used)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top