sheng12321
Newbie level 1
invalid device in subcircuit
Hi,L&G:
I just downloaded the pspice model from TI .And I use Orcad 10.5 for simulation.
I created a new library for the model,then FILE, Import design……
later,opened the *.olb to edit the symbol……oh,I also added the *.lib to the
library ,just as the picture given.
However,when I finished the schematic,and ran it,the errors came out.
such as:
WARNING -- Unable to find library file
Making new index file ucc380xp.ind for library file ucc380xp.lib
Index has 24 entries from 1 file(s).
ERROR -- Invalid device in subcircuit
ERROR -- Missing node
I did not find the *.IND ,and there was not *.slb .
So,who can tell me the correct adding methed? some type documents was
not generated ?Or I lost some steps? give me some suggestions
please.
regards
yours
sheng12321
Hi,L&G:
I just downloaded the pspice model from TI .And I use Orcad 10.5 for simulation.
I created a new library for the model,then FILE, Import design……
later,opened the *.olb to edit the symbol……oh,I also added the *.lib to the
library ,just as the picture given.
However,when I finished the schematic,and ran it,the errors came out.
such as:
WARNING -- Unable to find library file
Making new index file ucc380xp.ind for library file ucc380xp.lib
Index has 24 entries from 1 file(s).
ERROR -- Invalid device in subcircuit
ERROR -- Missing node
I did not find the *.IND ,and there was not *.slb .
So,who can tell me the correct adding methed? some type documents was
not generated ?Or I lost some steps? give me some suggestions
please.
regards
yours
sheng12321