Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Problems in: Co-simulation ADS2011 and EMpro2013

Status
Not open for further replies.
C

chipvc

Newbie level 2
Joined
Sep 28, 2010
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,295
Dear all,

I'm doing co-simulation ADS and EMpro. Following are my steps,

1. Simulate a simple project Microstrip line of two ports in EMpro 2013 (student license)
2. Save the project as a library
3. Open ADS (using ADS 2011) and add the library to ADS project. This lib. was attached in the post

I added two terminals to simulate in ADS but it had errors: " ..ERROR: ML2:ML2:empro is not a layout view. " I wonder why this is not a layout view.

Untitled.jpg

Can you guys help me to figure out the problem?

Thanks,

Chi
 

Attachments

  • ML_50Ohm.zip
    54.1 KB · Views: 45

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top