Problem with programming 12f675 in Hi Tech C compiler

im using 12f675 ..with internal clock.. i am just tring to blink the led
.. but im not getting the result..plzz help me if u have a DEMO code in c.i amusing hi tech c compiler,, source code is in c...

this is the code i have used ..but not giving the result....


#include <htc.h>

#define _XTAL_FREQ 4000000 // oscillator frequ
ency for _delay()

// Config: ext reset, no code protect, no brownout detect, no watchdog,
// power-up timer enabled, 4MHz int clock
__CONFIG(MCLREN & UNPROTECT & BORDIS & WDTDIS & PWRTEN & INTIO);

void delay_ms(long );


void main()
{



TRISIO = 0b001010; // configure GP1 (only) as an output

// Main loop
while(1)
{
// turn on LED on GP1
GPIO1 = 1;


delay_ms(1000);
delay_ms(1000);

// turn off LED on GP1
GPIO1 = 0;

delay_ms(1000);
}
} // repeat forever
}
void delay_ms(long ms)
{
long i;

while (ms--)
for (i=0; i < 330; i++)
;
}

12f675 led

you should re-read the datasheet and see what the gpio ports are set to when it is powered up.

my experience is that you only start to program a mcu after you have read the datasheet at least 50x.

12f675 c code

check your fuse settings, some compilers will use osccal value automatily ie call 0x3ff in this case. give the osccal value while programming retlw value at 0x3ff