Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Problem with PML and Master/Slave boundaries in HFSS v10

Status
Not open for further replies.

ghaffer

Newbie level 6
Joined
Dec 17, 2002
Messages
14
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
43
site:www.edaboard.com pml hfss

Hello all

I am trying to do an oblique angle simulation in HFSS 10. When I assign Master/Slave boundaries to the waveguide and then assign PML to the both faces, it says that simulation could not be run due to the fact that Mater/Slave boundaries are touching with the PML boundaries and both of them dont have the same parameters!!!!!!!!

Can some one help me in resolving this problem?

What about the PML reference as Frequency Selective Surface?

Regards


Ghaffer
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top