Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Problem with plane segmentation in Protel 99SE

Status
Not open for further replies.
A

amjad

Full Member level 5
Joined
Dec 29, 2002
Messages
273
Helped
9
Reputation
18
Reaction score
5
Trophy points
1,298
Activity points
2,291
plane segmentation

In Protel99SE, I assigned power1 to a plane layer while creating it.
And I segmented power2 and power3 in this layer.
The power1 was segmented into two by mistake (the two segments of power1 totally isolated from each other) while segmenting power2 and power3.
But, there was no broken net error and no incomplete routing.
Could anyone explain how to catch this type of error?
Many thanks in advance.
 

Re: plane segmentation

You must do a visual check on planes yourself. There is no automatic DRC that will catch a broken net on the plane in Protel.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top