Telfo2002
Member level 1
Hi,
I'm using a JDM serial programmer variant (TE-20 model) for programming a 18f1320. Other pic chips are well programmed but this one not. I suspect reason could be a low MCLR voltage (between 12 and 12,30V on this programmer).
Some ideas for programming that chip using this programmer? How to increase voltage to 13V just using serial port signals?
Thanks in advance.
I'm using a JDM serial programmer variant (TE-20 model) for programming a 18f1320. Other pic chips are well programmed but this one not. I suspect reason could be a low MCLR voltage (between 12 and 12,30V on this programmer).
Some ideas for programming that chip using this programmer? How to increase voltage to 13V just using serial port signals?
Thanks in advance.