problem with low side of ir2110

Status
Not open for further replies.
C

chotu

Newbie level 2
Joined
Jun 13, 2012
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,294
hi , i m using ir2110 for my dc motor driver ckt . the problem comes when the input to the lin goes floating , please check if there is any error in the schematic i m providing pwm from a microcontroller at 10 kHz
 

Attachments

  • driver relay ckt.pdf
    12.2 KB · Views: 110

Can you upload the signal wave form from the micro-controller?
 

IR2110 has weak input pull-down resistors, so the input won't actually float. It may be the case, that you are driving it with a pull-up resistor in the microcontroller. In this case, you would want to place a stronger external pull-down.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…