djipe
Junior Member level 1
Hello,
Few days ago, I've baught a EZL-70 (TCP/IP <-> RS232 convertor).
I success to read the device through the ethernet but not through the serial port
On this device the request to plug Rx, Tx, 5V, GND, RTS and CTS.
I plugged all exceted RTS and CTS : I put a court-circuit between CTS and RTS on the card. I did it because on my future card (using pic) I do not have RTS or CTS.
Do you think it is realy important to connect both wires ?
Do anybody have used this device ?
In advance thanks for your answers
Few days ago, I've baught a EZL-70 (TCP/IP <-> RS232 convertor).
I success to read the device through the ethernet but not through the serial port
On this device the request to plug Rx, Tx, 5V, GND, RTS and CTS.
I plugged all exceted RTS and CTS : I put a court-circuit between CTS and RTS on the card. I did it because on my future card (using pic) I do not have RTS or CTS.
Do you think it is realy important to connect both wires ?
Do anybody have used this device ?
In advance thanks for your answers