Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Problem With a counter

Status
Not open for further replies.

saeed_pk

Full Member level 4
Joined
May 20, 2006
Messages
237
Helped
35
Reputation
68
Reaction score
28
Trophy points
1,308
Location
Islamabad, Pakistan
Activity points
2,655
cunter 74190 circuit

Hi All,
I m miaking a counter with 74LS190 but having problems when i make the circuit on the Data sheet (Motorola) I am confused what to do with Parallel load/input pins and their enable .
this is a counter that counts from 0-9
and what happens if i left unused pins open
plz tell me whether this ciruit is right or if u have any other suggestion like different IC ( Please give circuit too)
Thanx All
Bye
 

1st u check that the IC u Used is TTL or CMOS .
If IC is CMOS then grounding an unused pins , otherwise IC burnt out.
further I can give u a guideline after anlysing a counter, till then bye.
 

In any cmos circuit you should have any input in the air becouse it becomes an antena and destroy the device.
If you dont want any parallel load you shoul put the /Pl pin to an high level using an resistor for example 4.7K
The inputs of paralel load bit must be grounded
/Ce must be at low leve for the counter run
Regards
 

better not to keep the 74190 pins open, it will count in an unusual way.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top