Hello ,I am following the manual.i did put breaking points at the event handler.
I have attached a video where i try to press the step into "9" button and press the PB1 button.
I dont see the logic at what stage should i press PB1 button so i could see my GPIO -> IF register change in value?
Update:
Hello , PB1 is press button 1 on my board.the GPIO pin which triggers the odd interrupt.
I have some progress andi see my IF register change value when i press the push button and press resume .
But the IFC stays 0 all the time during the debbuging procces .(as shown in the attached video)
Why is that?
Thanks. https://usaupload.com/6SGZ/2023-02-16_18-41-36.mp4
Hello ,I am following the manual.i did put breaking points at the event handler.
I have attached a video where i try to press the step into "9" button and press the PB1 button.
I dont see the logic at what stage should i press PB1 button so i could see my GPIO -> IF register change in value?