Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

problem REST pin STM32

Status
Not open for further replies.
P

paul0

Newbie level 5
Joined
Dec 11, 2012
Messages
8
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,335
Hi all;

I have a problem with the reset pin of my STM32 MCU.
When I need to activate the reset the pin ( in red) I pull it to ground and then what happens is that the MCU crashes (burned).
the datasheet of the STM32 shows that there is an internal pull up resistor which in my opinion could cause the problem:

1) Is my design for the reset pin correct
2) did i have to put a resistor connected to Vdd outside the MCU
3)If yes what could cause the MCU failure


thanks
 

Attachments

  • Sans titre.png
    Sans titre.png
    39.4 KB · Views: 91
Last edited:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top