when i send data using rf module then data is not received at receiver. as i shown in diagram i have connect tx pin of controller to transmitter and rx pin to receiver.
for reference i have attached my code and program do
it transmit continous letter 'a' with delay
and received letter is shown on lcd.
controller is used is 6 clock per MC.
.... He had solved ny turning ON the transmitter board first and then powering ON the receiver board. ....
Hello masters
I have purchased RF module which is like **broken link removed** and i have two such modules and tried both using simple UART based protocol. But facing problem. So, help me to do communication.
My UART communication work fine and checked on hyper terminal.
i have attached circuit diagram in short images as follows.
Hello sir i had tried with 600 bits/second ,still this one is not working even i had tried with lowest and step by step upto 2400 bits/second.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?