Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] Problem in programming 18F4550 using Microburn

Status
Not open for further replies.

speedEC

Full Member level 6
Joined
Apr 1, 2011
Messages
337
Helped
23
Reputation
46
Reaction score
21
Trophy points
1,298
Activity points
4,324
Dear Sir,

I already completed interfacing GSM Modem with PIC16F877A Project. Now, I tried on 18F4550. Just I tried to write sample (LED) program on PIC18F4550 using microburn software (PIC PLUS ICSP Programmer), I can able to write only one time. If I just modified the code or try to reprogram the chip with other program (say USART.c) error occurred. "Error at Address 0x0000 Good at:..... Bad at...". I left all the fuse settings as default except OSC (4MHZ), Disable WDT. I thought the PIC might be faulty so I bought new one. But the same result. Can any one help me? Advance Thanks.
 

Might be PIC Damaged. So, I have moved to PIC18F452 and it works fine with GSM Modem.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top