problem during programming of at89c5132

[deepaknaik26]

To program the AT89C5132 we have used FLIP-2.4.4 software.
I have installed Flip on a fresh computer. When I have connected my hardware first time I programmed successfully. After that I unplug the device and connected once again.

At the Pc end I get this error."USB device is not recognised "

If Ihave tried to install once again the driver then I get " The specified location is not contain information about new hardware ".

The program I have loaded in the microcontroller is perfectly working.

If I install in the othe PC ( fresh installation) first time it works and after unplug the device it gives the eroor mensionde above.

Please give any idea to solve this problem.

 

[Jos Brink]

Hi,

I'm also trying to work with Flip. the thing u say about "device not regonised" looks like the wrong reset sequence. First plug in the usb and next give a short reset. This worked for me.

also check this pdf:
http://www.atmel.com/dyn/resources/prod_documents/doc4282.pdf

But i have another problem. Once connected. I'm unable to program any chip. I get the "time-out" error all the time. Maybe you could help me with that?

Thnx and greetz from holland!

Jos Brink

 

[deepaknaik26]

hi


Program ur mc by unsetting BLJB bit.
After that once u program . Press the reset button. Ur program will execute. To put the device in isp mode press ISP button then press reset ,, release the reset , after that release the isp pin.

This will put the device in isp mode.

By

 

[nnvkct]

Hi,

check this pdf:
h**p://www.atmel.com/dyn/resources/prod_documents/doc4282.pdf