raviram80
Member level 3
Hi All,
I have a question about PT commands
There are three commands
1. Check_timing
2. Update_timing
3 Report_timing
Out of all these three which is the one where the actual Primetime analysis is taking place, that is where the final hold or setup violation is calculated for each net or gate
Thanks,
R
I have a question about PT commands
There are three commands
1. Check_timing
2. Update_timing
3 Report_timing
Out of all these three which is the one where the actual Primetime analysis is taking place, that is where the final hold or setup violation is calculated for each net or gate
Thanks,
R