taring77
Full Member level 2
Hi
any one know how do i seperate two planes in a layer.??
i did these steps but end up only one plane is connected.
Layer defination => Split/Mix Cam
Add net 1.5V & 3.3V
Draw Plane => Middle to left board is 1.5V net
Middle to right board is 3.3V net
Setup => Flood => plane connect ( only the particular layer name is there )
only 3.3V is plane connect ( flooded )
please help
taring
any one know how do i seperate two planes in a layer.??
i did these steps but end up only one plane is connected.
Layer defination => Split/Mix Cam
Add net 1.5V & 3.3V
Draw Plane => Middle to left board is 1.5V net
Middle to right board is 3.3V net
Setup => Flood => plane connect ( only the particular layer name is there )
only 3.3V is plane connect ( flooded )
please help
taring