Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

PowerPCB/PADS viewing through holes problem

Status
Not open for further replies.

nzkunal

Member level 2
Joined
Mar 11, 2004
Messages
52
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
377
For some reason I can't see the thru-holes pads in power PCB. The component outline is still visible. SMD design components appear as normal. Any ideas?
 

try this:

setup--->preferenes-->global-->select "active layer comes to front"
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top